Pontiac Injection Mould Set (70mm) - 1 Cavity
Pontiac Injection Mould Set (70mm) - 1 Cavity Pontiac Injection Mould Set (70mm) - 1 Cavity

Pontiac Injection Mould Set (70mm) - 1 Cavity

Product Code: Injection Mould #27
Reward Points: 0
Price: AU$449.99
Ex Tax: AU$409.08
   - OR -   

This kit comes with a one cavity two piece 'Pontiac' style injection mould and an alumnium two cavity two piece lead insert mould. Insert wire kits are sold separately and contain crimps, nylon coated stainless wire and figure eight wire forms that are used with this mould. Premium US Plastisol 'Hard' is the common plastic used when making this style of lure and is what we recommend for lures made with this mould. You can remove the 10mm tail to make a smaller lure. 


Make your own pontiac soft plastic Lures.

Begin by making your wires.

Crimp the first loop using the insert mould.

Place the looped end in the mould and measure wire to edge of mould.

Put the crimp on and slide it up so it fits into the Mould.

Crimp and remove excess wire.

(Make as many wires as you require).

Place wires and figure 8's into Insert Mould, close and you are ready to pour.

Please note only soft lead is to be used as wheel weights are too hard.  We recommend roofing lead or sheet lead. 

Heat the mould a little and once your lead is heated you can pour into the mould.

Open the mould and remove inserts.

(Repeat until you have required number of inserts)

From here it is the same as making lures using any other soft plastic injection mould.

Place the inserts into the Pontiac Mould and close, making sure the mould closes correctly.

Heat your plastic, suck some into your injector and squirt it back into the pot.  This will heat the injector which ensures an easy injection of plastic.  The injector and the injection mould will get very hot so wear protective clothing (gloves, long sleeved shirts, boots, eye protection and a mask).

When you are ready, reheat and inject your plastic.  Leave a few minutes to set, up to 10 minutes when the mould is very hot.

Two coloured lures can be made by using the method of pour and inject.  Follow the instructions below:-

Heat your two colours, suck up one colour into injector.

Leave the injector in the jug of plastic to keep it hot.

Pour (from a jug) a small amount of your first colour and then immediately inject the second colour.

We recommend and suggest you use Hard Plastic for these lures.

Should the lures get damaged or torn, you can still recycle the plastic and use the insert to make more lures.

Parts Required to make Lead Inserts

No 5 Figure 8 wires.

60lb - 49 strand nylon coated wire. 

Crimps to suit.

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: